Sanha NiroSan Press Fit Female x Male Threaded Bend 90

The Sanha NiroSan Press Fit Female x Male Threaded Bend 90° is expertly crafted for connecting a press-fit system with a female threaded component through a 90-degree angle. The female press-fit end attaches to the piping system, while the male threaded end is designed for insertion into a female threaded fixture, facilitating a seamless and effective connection within the system.

• Functional Design: Equipped with a female press-fit end for direct connection to press-fit piping and a male threaded end for compatibility with female threaded fixtures.
• Material Quality: Made from high-grade 1.4404 stainless steel for moulded parts and 1.4408 for threaded parts, ensuring superior corrosion resistance compared to conventional materials.
• Durability: Features a long service life, supported by an EPDM sealing ring known for its robustness and reliability.
• Certifications: WRAS-tested and certified, ensuring compliance with rigorous health and safety standards.
• Temperature and Pressure Ratings: Capable of handling a broad range of operating temperatures (-30 °C to +120 °C) and pressures, varying according to size (up to 40 bar for smaller diameters).
• Broad Application Spectrum: Suitable for a multitude of systems, from potable water to technical gases and cooling systems, reflecting its versatility in different industrial and commercial settings.
• Certifications: WRAS-certified, ensuring it meets the standards required for safe use in potable water systems.

• Product Codes: 69002AG1512, 69002AG2234
• Available Sizes: 15mm x 1/2", 22mm x 3/4"
• Pressing Profile: SA, M and V Profile
• Materials: 1.4404 (AISI 316L) stainless steel
• Sealing Ring: EPDM
• Operating Conditions: Varies with diameter - up to 40 bar for ≤22 mm, 25 bar for 28–35 mm, and 16 bar for 42–168.3 mm.
• Temperature Range: -30 °C to +120 °C
• Range: NiroSan Series 9000
• Approvals: BSI / Kitemark & WRAS

1. Preparation: Use a roller pipe cutter or a fine-toothed saw ensuring no tarnish. Avoid high cutting speeds to prevent stainless steel sensitisation.
2. Deburring: Thoroughly deburr the tube end inside and out, removing all residues.
3. Insertion Depth: Mark the insertion depth on the tube or fitting, ensuring accurate installation.
4. Sealing Ring Inspection: Ensure the sealing ring is correctly positioned and free from damage.
5. Connection: Insert the pipe end into the fitting until it reaches the depth mark, ensuring a secure and proper fit.

For detailed installation instructions, including pressing jaw selection and pressing process, refer to the SANHA installation guide below.