Paragon Underground Drainage Single Socket Bend 15°

Designed for the smallest of directional adjustments, this 15° bend has a chamfered spigot on one leg and a push-fit ring seal socket on the other. The spigot pushes straight into the socket of a single socket pipe, a junction or another bend. This allows a fine correction to be made directly at a fitting, where there may be no room for an additional length of pipe.

It is particularly useful where a run must leave a junction or bend at a fractionally different angle to line up with the next section of drain, or with a connection into a chamber. Joined spigot to socket, two 15° single socket bends combine into a compact 30° turn. A 15° bend can also be paired with a 30° or 45° bend to reach intermediate angles not covered by a single fitting.

• 15° angle: A very shallow change of direction for fine corrections to the line of a run.
• Spigot and socket ends: One push-fit socket and one spigot allow the bend to connect directly into another fitting or socketed pipe.
• Chamfered spigot: The spigot end is moulded with a chamfer, ready for insertion into a ring seal socket.
• Combined angles: Pairs with other bends to build intermediate angles in a compact arrangement.
• Push-fit ring seal: The socket carries a ring seal for push-fit jointing, with no solvent cement required.
• Two sizes: Available in 110mm and 160mm, to suit the matching Paragon pipe diameters.
• Recognised standard: Manufactured in accordance with BS EN 1401-1.
• New build and refurbishment: Suited to round the house drainage on new build projects and to the refurbishment or replacement of existing drains.
• Made in Great Britain: Manufactured in Great Britain by Polypipe, and finished in terracotta.