Pipe Repair & Testing Tools

Pipe repair and testing are essential practices in plumbing, utility maintenance, and infrastructure management. Whether dealing with leaks, damage, or new installations, these processes ensure the integrity, safety, and compliance of water, gas, and waste systems.

Pipe repair methods vary depending on the material and severity of the damage—ranging from simple clamp fixes to full-length replacements. Mechanical pipe repair products like wraps, clamps, and couplings provide fast, reliable solutions for pressurised and non-pressurised systems.

Pipe testing confirms the performance and safety of installations before systems go live. This includes pressure testing (hydrostatic or air), continuity testing for MDPE electrofusion joints, and leak detection. Accurate testing is critical to meet standards and avoid costly failures.

Both repair and testing are key to minimising downtime, ensuring system longevity, and maintaining compliance with relevant standards and regulations.

Minor leak with clamp or wrap (accessible area):

• 15–60 minutes – Quick fixes using repair clamps or epoxy wraps on accessible pipes.

Sectional pipe replacement (e.g. under sink or exposed pipe):

• 1–3 hours – Cutting out damaged section and replacing with couplings or unions.

Underground pipe repair (e.g. MDPE or clay):

• 4–8 hours or more – Includes excavation, repair, and backfilling.

Pressurised pipe systems (e.g. heating or mains water):

• 2–6 hours – Time includes depressurising, repair, testing, and re-commissioning.

Emergency burst pipe response (internal):

• 1–4 hours – Depends on isolation, accessibility, and material.

Fill the system with water and bleed all air. Cap ends and connect a pressure test pump. Gradually pressurise the system to the required level (usually 1.5 times working pressure) and hold for at least 10 minutes. Check for leaks or pressure drops. If stable, record the result as a pass. Always follow safety guidelines and local standards.