Paragon Underground Drainage Single Socket Bend 11.25°

Offering the finest angle in the range, this 11.25° bend pairs a chamfered spigot on one leg with a push-fit ring seal socket on the other. The spigot inserts directly into the socket of a single socket pipe, a junction or another bend. This allows a barely perceptible change of direction to be made right at the fitting, without a short length of pipe in between.

The bend is well suited to trimming the exit angle from a junction or bend so the run lines up exactly with the next section of drain or a chamber connection. On refurbishment work, it can take up a small misalignment where new pipework meets an existing socket. It can also be coupled with a 15° or 30° single socket bend to reach an intermediate angle in a compact arrangement.

• 11.25° angle: The shallowest change of direction in the range, for the finest corrections to a run.
• Spigot and socket ends: One push-fit socket and one spigot allow the bend to connect directly into another fitting or socketed pipe.
• Chamfered spigot: The spigot end is moulded with a chamfer, ready for insertion into a ring seal socket.
• Combined angles: Pairs with other bends to build intermediate angles in a compact arrangement.
• Push-fit ring seal: The socket carries a ring seal for push-fit jointing, with no solvent cement required.
• 110mm size: Sized to suit the Paragon 110mm pipe and fittings.
• Recognised standard: Manufactured in accordance with BS EN 1401-1.
• New build and refurbishment: Suited to round the house drainage on new build projects and to the refurbishment or replacement of existing drains.
• Made in Great Britain: Manufactured in Great Britain by Polypipe, and finished in terracotta.