Paragon Underground Drainage Single Socket Bend 87.5°

This bend changes the direction of a below ground drain run through 87.5°, with a push-fit ring seal socket on one leg and a spigot on the other. The spigot end is moulded with a chamfer during manufacture. It inserts directly into the socket of a single socket pipe, a coupler or another fitting, so the bend can be close-coupled to adjacent fittings without a short length of pipe in between. The socketed leg receives plain ended pipe or a spigot fitting in the usual way.

Close coupling like this is useful where space is tight, such as turning a run close to a building, or pairing the bend with a junction or a second bend to form an offset. As with the double socket version, the 2.5° short of a right angle leaves a slight fall on the horizontal leg when turning from vertical to horizontal. The bend is available in 110mm and 160mm for non-pressure foul and surface water drainage.

• 87.5° angle: Provides an 87.5° change of direction in the drain run.
• Spigot and socket ends: One push-fit socket and one spigot allow the bend to connect directly into another socketed fitting or pipe.
• Chamfered spigot: The spigot end is moulded with a chamfer, ready for insertion into a ring seal socket.
• Close coupling: Joining straight into adjacent fittings removes the need for a short intermediate pipe length.
• Push-fit ring seal: The socket carries a ring seal for push-fit jointing, with no solvent cement required.
• Two sizes: Available in 110mm and 160mm, to suit the matching Paragon pipe diameters.
• Recognised standard: Manufactured in accordance with BS EN 1401-1.
• New build and refurbishment: Suited to round the house drainage on new build projects and to the refurbishment or replacement of existing drains.
• Made in Great Britain: Manufactured in Great Britain by Polypipe and finished in terracotta.