Paragon Underground Drainage Bottle Gulley

This bottle gully combines a ground-level inlet and a trap in a single compact body. It collects surface water or waste water at the surface and discharges it through a 110mm side outlet into the below ground drain. Water enters through the grid at the top and passes down an internal tube into the base of the body. It then rises to leave through the side outlet. The water retained in the base forms a seal that prevents foul air from the drain escaping at ground level.

Because the trap is formed inside the body rather than in a separate U-bend below, the gully is compact in both height and footprint. This suits locations where excavation depth or space is limited, such as close to walls or around existing foundations. The round grid sits in the top of the gully, allowing water through while holding back leaves and debris. Moulded feet at the base give the fitting a stable footing when bedded.

• Integral bottle trap: The trap is formed within the body, retaining a water seal to prevent drain odours escaping at ground level.
• Compact design: Inlet and trap in one body reduce the depth and space needed compared with a separate trap and hopper.
• 110mm side outlet: Connects directly into Paragon 110mm below ground pipework and fittings.
• Round grid: The grid at the top lets water through while keeping debris out of the drain.
• Support feet: Moulded feet at the base provide a stable footing for bedding.
• Recognised standard: Manufactured in accordance with BS 4660.
• Made in Great Britain: Manufactured in Great Britain by Polypipe, and finished in terracotta.