Paragon Underground Drainage Reducer

This reducer connects 110mm and 160mm pipework within a below ground drainage system, providing an in-line transition between the two sizes. It is typically used where a 110mm run joins into a larger 160mm drain, for example where several 110mm branches combine into a 160mm main serving a larger property or development.

The larger end is a 160mm spigot, moulded with a chamfer, which pushes directly into a 160mm socket on a pipe, coupler or fitting. The smaller end carries a 110mm push-fit ring seal socket that receives 110mm plain ended pipe or a spigot fitting. With a socket on one side and a spigot on the other, the reducer joints straight into both sizes of pipework without additional couplers.

• Size transition: Connects 110mm and 160mm pipework in line, in a single fitting.
• 160mm spigot: The larger end inserts directly into any 160mm socket in the system.
• 110mm ring seal socket: The smaller end receives 110mm plain ended pipe or spigot fittings with a push-fit joint.
• Chamfered spigot: The spigot end is moulded with a chamfer, ready for insertion into a ring seal socket.
• No extra couplers: Spigot and socket ends joint straight into both pipe sizes.
• Recognised standard: Manufactured in accordance with BS EN 1401-1.
• New build and refurbishment: Suited to round the house drainage on new build projects and to the refurbishment or replacement of existing drains.
• Made in Great Britain: Manufactured in Great Britain by Polypipe, and finished in terracotta.