Paragon Underground Drainage Double Socket Coupler

This coupler joins two plain pipe ends in a straight line, with a push-fit ring seal socket at each end receiving the pipe or spigot fitting on either side. On new drain runs, it connects consecutive lengths of plain ended pipe, or brings a cut length back into the run. On refurbishment and repair work, it is commonly used to reinstate a drain where a damaged section has been cut out and a replacement length inserted.

The coupler forms a continuous in-line joint with no change of direction, keeping the drain run on its existing line and gradient. It is available in 110mm and 160mm to suit the matching pipe diameters.

• Double socket design: A socket at each end allows two plain pipe ends to be joined in a straight line.
• Push-fit ring seal: Each socket carries a ring seal for push-fit jointing, with no solvent cement required.
• Two sizes: Available in 110mm and 160mm, to suit the matching Paragon pipe diameters.
• Recognised standard: Manufactured in accordance with BS EN 1401-1.
• Foul and surface water: Suitable for non-pressure foul and surface water disposal below ground.
• New build and refurbishment: Suited to round the house drainage on new build projects and to the refurbishment or replacement of existing drains.
• Terracotta finish: Supplied in terracotta, matching the Paragon 110mm and 160mm pipe and fittings.
• Made in Great Britain: Manufactured in Great Britain by Polypipe.