Paragon Underground Drainage Double Socket Bend 11.25°

As the shallowest bend in the Paragon below ground range, this 11.25° fitting makes the finest adjustment available to the line of a drain run. It is used where even a 15° bend would overcorrect. Typical cases include a new run that must meet an existing pipe or chamber connection only slightly off its line, or a section of replacement pipework that needs easing back into alignment with the original drain.

Each leg is fitted with a push-fit ring seal socket, so plain ended pipe or spigot fittings join directly into both ends without a coupler. Because the angle is so slight, a series of these bends spaced along a run can trace a very gentle curve. They can also be combined with 15° or 30° bends to fine-tune the overall change of direction.

• 11.25° angle: The shallowest change of direction in the range, for the finest corrections to a run.
• Double socket design: A socket on each leg accepts plain pipe ends or spigot fittings on both sides of the bend.
• Fine-tuning angles: Combines with other bends to set an exact overall change of direction.
• Push-fit ring seal: Each socket carries a ring seal for push-fit jointing, with no solvent cement required.
• 110mm size: Sized to suit the Paragon 110mm pipe and fittings.
• Recognised standard: Manufactured in accordance with BS EN 1401-1.
• New build and refurbishment: Suited to round the house drainage on new build projects and to the refurbishment or replacement of existing drains.
• Made in Great Britain: Manufactured in Great Britain by Polypipe, and finished in terracotta.