Paragon Underground Drainage Universal Gulley Trap

This gully trap forms the collection point where surface water or waste water enters the below ground drain. Water enters through a vertical 110mm socketed inlet, passes down into a U-shaped trap at the base, and leaves through an angled spigot outlet that rises away towards the drain run. The trap retains a body of water at its lowest point. This forms a seal that stops foul air from the drain escaping back up through the inlet at ground level.

The inlet socket carries a push-fit ring seal and is designed to receive a hopper or a vertical length of 110mm pipe bringing the inlet up to the finished ground level. The angled spigot outlet is moulded with a chamfer and pushes directly into the socket of a bend or pipe, so the outgoing connection can be turned to meet the drain at the required line. A flat support fin moulded beneath the trap gives the fitting a stable base when bedded.

• Integral trap: The U-bend at the base retains a water seal to prevent drain odours escaping at ground level.
• Socket inlet: A 110mm push-fit ring seal socket receives a hopper or vertical pipe from above.
• Spigot outlet: The chamfered spigot outlet pushes directly into a socketed bend or pipe leading to the drain run.
• Support fin: A moulded fin beneath the trap provides a stable base for bedding.
• Recognised standard: Manufactured in accordance with BS 4660.
• New build and refurbishment: Suited to round the house drainage on new build projects and to the refurbishment or replacement of existing drains.
• Made in Great Britain: Manufactured in Great Britain by Polypipe, and finished in terracotta.