Paragon Underground Drainage Double Socket Bend 87.5°

Turning a drain run through 87.5°, this bend is used where below ground pipework changes direction. Typical positions include the corner of a building, or the point where a vertical connection from a gully, hopper or rainwater downpipe meets the horizontal drain. The angle falls 2.5° short of a right angle, so a horizontal leg joined to a vertical one is left with a slight fall, keeping the run self-draining.

A push-fit ring seal socket is formed on both legs. Plain ended pipe or spigot fittings can therefore be jointed directly on either side, with no coupler needed at the bend. This allows the bend to be positioned between two cut pipe ends. The bend is available in 110mm and 160mm for non-pressure foul and surface water drainage.

• 87.5° angle: Provides an 87.5° change of direction in the drain run.
• Double socket design: A socket at each end accepts plain pipe ends or spigot fittings on both sides of the bend.
• Push-fit ring seal: Each socket carries a ring seal for push-fit jointing, with no solvent cement required.
• Two sizes: Available in 110mm and 160mm, to suit the matching Paragon pipe diameters.
• Recognised standard: Manufactured in accordance with BS EN 1401-1.
• Foul and surface water: Suitable for non-pressure foul and surface water disposal below ground.
• New build and refurbishment: Suited to round the house drainage on new build projects and to the refurbishment or replacement of existing drains.
• Terracotta finish: Supplied in terracotta, matching the Paragon 110mm and 160mm pipe and fittings.
• Made in Great Britain: Manufactured in Great Britain by Polypipe.