PVCu Underground Drainage Adjustable Bend 90

• Material: PVCu
• Colour: Terracotta (system match)
• Diameter: 110mm 
• Angle: Adjustable 0–90° on site (set to suit the run)
• Ends: Socketed ends to suit plain pipe/spigot (as per SKU)
• Jointing: Push-fit ring-seal (no solvent required)
• Application: Fine alignment where fixed-angle bends are impractical or where last-minute adjustments are needed
• Standards & Approvals: BS EN 1401; BS 4660:2000 (where applicable)
• Manufactured: United Kingdom

This adjustable bend allows the installer to set any angle up to 90° on site, making it ideal for navigating obstacles, tying into legacy layouts, or achieving precise gradients without resorting to multiple fixed-angle fittings. The configurable geometry helps reduce cutting and waste, while maintaining smooth internal flow paths to support hydraulic performance. Assembly is straightforward: position the bend to the required angle and push-fit onto plain pipe or spigot ends to achieve a reliable, watertight joint.

Manufactured from rigid, corrosion-resistant PVCu in traditional terracotta, the fitting withstands typical trench conditions and routine handling. Push-fit ring-seal jointing speeds installation, avoids solvent cement, and simplifies any subsequent re-alignment during commissioning. Suitable for correctly configured foul and surface water systems and compatible with installations to BS EN 1401 and BS 4660:2000 (where applicable), it delivers a flexible, low-maintenance solution for accurate underground routing.

• On-site angle setting up to 90° for precise alignment
• Fewer fittings and cuts versus fixed-angle alternatives
• Smooth internal bore helps maintain flow and reduce silt traps
• Fast, solvent-free push-fit assembly for clean installs
• Durable PVCu construction with system-matched terracotta finish